The mixing machine works in an environment with a lot of ash and sand. Therefore, in order to ensure the reliability of the machine and reduce the wear of machine parts and the loss of power, lubrication should be done in time, otherwise impurities such as ash and sand will seriously wear and block the equipment. Normal use. Let's follow the editor of Marshmallow extruder to learn about its lubrication work!

1. The gears and bearings of the mixing machine reducer use gear rotation to splash the oil on the inner wall of the box and flow into the bearings for lubrication. The oil level of the gearbox should be kept between the two engraved lines of the oil dipstick. Too high or too low oil level will cause temperature rise or poor lubrication of various parts, increase power loss and cause poor machine operation. The engine oil should be changed once for the first 150 hours and 300 hours of the new machine in order to remove the dirt that was not completely cleaned during the test run. When working, check the oil level frequently, and make up for any deficiency in time.
2. All exposed parts that need to be adjusted and rotation matching positions should always be kept with lubricating oil. However, the brake belt part must not be contaminated with oil and water, so as not to affect the braking effect.
3. The lubrication of the motor is carried out according to the motor manual.
4. Other lubrication positions and lubrication periods of the mixing machine shall be carried out in accordance with the lubrication schedule.
In summary, the editor of Marshmallow extruder tells the introduction of the lubrication work of the mixing machine. I hope you can learn more through the introduction of the editor.